RLED CC Dimming LED Driver

Description

Wireless Constant Current Dimming LED Drivers

RLED45CC1

Single Channel 45W

A 45W constant current LED dimmer with in-built RF receiver and Rako processor for constant current LED fittings. Selectable outputs of 350, 500, 600, 700 and 1000mA with a forward voltage range of 3-45V DC. The RLED45CC1 is fed from a suitable DC power supply to provide an adequate forward voltage, Rako recommends the RAPSU48. The module is connected in-line before the first fitting and can control up to 13 LEDs in series (note: some fittings may use multiple LEDs, if in doubt refer to Rako’s technical department) with a maximum wattage of 45W.

RLED20CC3

Three channel 20W/channel

Controlled from any Rako Rakom device, e.g. RCM wall plates or Bridge interface units. For control of 3 channel constant current LED fittings with selectable outputs of 350, 500, 600 and 700mA. When used with 3 colour fittings each colour is allocated a channel and can be individually adjusted allowing complete colour mixing. Simple colour cycling is started/stopped using the raise/lower buttons in a Rako wall panel or hand held remote. We are an approved distributor for Rako products so if you cannot see what you are looking for or you need any help selecting the right Rako products or anything else for your project then why not give us a call or send us an email and one of our team will be happy to help you out.